Product Preview

Feb. 1, 2006
Finn The T60 HydroSeeder is designed to offer professional quality hydroseeding by allowing users to apply various blends of seed, fertilizer, fiber mulch

Finn

The T60 HydroSeeder is designed to offer professional quality hydroseeding by allowing users to apply various blends of seed, fertilizer, fiber mulch and growth-enhancing additives in one labor-saving step for cost-efficiency and productivity. The T60 features a 600-gallon working capacity tank covering up to 7,200 square feet per load with spray distances up to 90 feet from the discharge gun. Other features include a hydraulically controlled paddle agitator and liquid recirculation; agitator controls at each end of the tank for operator convenience; and a large toolbox in the hitch for storing hoses and nozzles.
Booth 6524
Circle 200 on Reply Card
freeproductinfo.net/rer

Multiquip

Multiquip's new MVC-80 Series vibratory plate compactors reduce vibration by 50 percent when compared to predecessor models, courtesy of a new anti-vibration system. The new handle design reduces operator fatigue while boosting productivity. With centrifugal force of 2,925 pounds, the MVC-80 is suited for compacting granular soils and asphalt. At maximum speed, the unit can compact up to 72 feet of material per minute. The forward plate compactors are offered with 5.7-hp Honda and 5.5-hp Robin gasoline engines and have exciter speeds of 5,580 rpm.
Booths 6215 and 1618
Circle 401 on Reply Card
freeproductinfo.net/rer

Electric Eel

The new Model Z5 drain cleaner from Electric Eel is designed for longer runs in 1¼- to 3-inch drain lines. The Z5 comes standard with ½-inch by 75-foot galvanized aircraft wire inner core cable powered by a heavy-duty 1/3-hp Baldor motor. Large, 10-inch wheels make the Z5 easy to maneuver, and a folding handle allows for easy transport and storage. The Z5 is equipped with a wheel brake that stabilizes the unit while in operation. A cable guide and inner drum eliminate cable tangling in the cage. Plus, a ground fault circuit interrupter, an air foot switch, a versatile 5-piece tool set, and a drum-shaft safety slip clutch are all standard.
Booth 5114
Circle 402 on Reply Card
freeproductinfo.net/rer

CM Diamond Blades

The CM Diamond Blades 14-inch dry/wet cutting saw weighs 68 pounds and features a dry cut, dust-free system that allows dry cutting without bothersome and unhealthy dust. There is no width limit of cutting, allowing the operator to cut more than 20 inches wide. The handle is suited for both right- and left-handed users.
Booth 5062
Circle 403 on Reply Card
freeproductinfo.net/rer

Tanaka

The TLE-600 shaft/gear-driven, walk-behind edger from Tanaka features an optimized 50 cc, 2.5-hp Tanaka 2-stroke engine, an update over the previous TLE-550 model. The edger also has a 10.5-mm, solid-steel drive shaft and heavy-duty, two-stage air filtration system. The TLE-600 also has a hand-lever-activated height-adjustment system; large, rounded front wheel; and optional drop wheel/curb riding kit. The TLE-600 also complies with EPA emissions standards.
Booth 4923
Circle 404 on Reply Card
freeproductinfo.net/rer

Allied Construction Products

Allied Construction Products' line of Ho-Pac compactor/drivers includes models 500, 1000, 1600 and 2300. A larger eccentric with mass farther away from the shaft centerline helps to increase impulse and compaction force. The oil splash provides maintenance-free bearing lubrication. Base plates can be unbolted easily to allow replacement with a different size or custom attachment. The Ho-Pacs also include new hose routing for better protection against sheared or damaged hoses. As a compactor, Ho-Pacs can be used for trench, slope and excavation compaction, as well as for compacting waste materials and for breaking up frozen coal. As a driver, Ho-Pacs offer a technique for driving wood, steel and aluminum sheeting, H and I beams, piling, posts and sea walls.
Booth 2862
Circle 405 on Reply Card
freeproductinfo.net/rer

Wacker

The new Wacker BS 50-4s and BS 60-5s rammers feature low-oil shutoff in their 4-cycle WM 90 engine. The electronic capacitive sensor switch is mounted into the bottom of the engine crankcase. Upon starting the units, should the sensor detect no oil or low oil, a red, flashing light signals the operator and the engine will shut off within about 10 seconds. The rammer is powered by a 2.8-hp engine, specifically designed to withstand the vibration of a rammer application. The BS 50-4s weighs 137 pounds and hits with 2,645 pounds per blow at a rate of 680 blows per minute and is capable of achieving a compaction depth up to 18 inches. The BS 60-4s weighs 154 pounds, hits with 2,975 pounds per blow at a rate of 680 blows per minute and reaches compaction depths up to 22 inches.
Booths 5220 and 5332
Circle 406 on Reply Card
freeproductinfo.net/rer

Shark Pressure Washers

Shark Pressure Washers' two new extra-small, gasoline-powered hot water pressure washers deliver cleaning power of up to 2,400 psi and weigh only 300 pounds. The SGP-Mini needs no battery to power the burner. A constant supply of 12-volt DC power is produced by a Robin engine coupled with Shark's super-duty regulator. The SGP-Mini heats the water with a diesel or oil-fired Beckett burner and produces a water stream of up to 2.7 gpm. The units are powered by 6- and 7-hp Robin engines. Other features include four, 13-inch pneumatic tires; spring-loaded, insulated trigger gun with insulated, variable-pressure wand; blue, color-coded, non-marking hose; and adjustable thermostat and hour meter.
Booth 5530
Circle 407 on Reply Card
freeproductinfo.net/rer

Ditch Witch

The new Ditch Witch SK650 mini skid steer is equipped with a 31-hp Kubota turbo diesel engine and directs 20 net hp to the attachment. Quick-disconnect attachment fittings enable attachments to be changed with the hydraulic system under pressure, which speeds productivity. The SK650 is also equipped with a foot pedal auxiliary control that allows the operator to drive the attachment by foot, freeing up his hands to control depth and ground speed. An attachment-level indicator is mounted on the attachment lift frame, allowing the operator to see from the operator's station if the attachment is level. Pilot control valves for ground drive provide responsive steering with little or no vibration through the control handles, minimizing operator fatigue.
Booth 2702
Circle 408 on Reply Card
freeproductinfo.net/rer

General Pipe Cleaners

The Easy Rooter Junior from General Pipe Cleaners features a 1/3-hp capacitor motor that can drive up to 100 feet of ½-inch Flexicore wire rope center cable. The drain cleaner rolls on 8-inch ball bearing semi-pneumatic tires. A folding handle allows the Easy Rooter Junior to load into a car trunk and, if necessary, the cage can be removed from the frame in less than a minute. A safety slip clutch, ground fault interrupter, pneumatic foot pedal and instructional video are standard equipment.
Booth 4402
Circle 409 on Reply Card
freeproductinfo.net/rer

MBW

MBW introduces the MK8-75H ride-on trowel. The 320-pound, 13-hp Lowrider features twin 30-inch rotors, an edger system for finishing nearly flush to walls, and can be equipped with finish or combo blades and float pans. The trowel can be placed on concrete sooner than heavier machines and is able to pass through 32-inch doorways. The MK8-75H features synchronized steering and three rollers on its front guard ring, enabling the machine to finish within approximately ¼-inch of a wall. The trowel can be transported in the bed of a standard pickup truck.
Booth 5728
Circle 410 on Reply Card
freeproductinfo.net/rer